Daily Inspection - TOHATSU M 60C Owner's Manual

Hide thumbs Also See for M 60C:
Table of Contents

Advertisement

ENOM0716-0

1. Daily inspection

Perform the following checks and inspec-
tion before and after use.
Item
• Check the amount of fuel in the tank.
Fuel System
• Check for dust or water in the fuel filter.
• Check rubber pipes for oil leakage.
• Check the amount of engine oil in the oil tank.
Lubrication
System
• Check for dust or water in the oil filters.
• Check the spark plugs for dirt, wear and carbon built-up.
Spark plugs NGK B8HS-10 or BR8HS-10 (1.0 mm gap) (0.0394 in)
• Check if the main switch functions normality.
• Check if the battery electrolyte level and specific gravity are normal
Electrical
Equipment
• Check for loose connections on battery terminal.
• Check if the stop switch functions normally and make sure the lock
plate is present.
• Check cords for loose connections and damage.
• Check that the choke solenoid and valve for the carburetor works
normally.
Throttle
System
• Check if the carburetor and magneto work normally when turning the
throttle grip, and also check links for looseness.
• Check if the clutch engages correctly when operating the Remote
Clutch and
Control. (or Shift lever)
Propeller Sys-
• Check the propeller for bent or damaged blades.
tem
• Check if the propeller nut is tightened and the split pin is present.
• Check all the motor installation bolts with the boat.
Installation of
Motor
• Check the thrust rod installation.
Power Trim &
• Check working of the tilt up and down of the motor.
Tilt
• Check that cooling water is discharged from the cooling water check
Cooling Water
port after the engine has started.
• To be prepare tools and spare parts for replacing spark plugs, pro-
Tools and
peller, etc.
Spares
• Check if the spare rope is provided.
Steering
• Check working of steering handle and remote control.
Devices
• Check if the anode and trim tab are securely installed.
Other parts
• Check the anode and trim tab for corrosion and deformation.
*1 Have this handled by your dealer.
INSPECTION AND MAINTENANCE
ENOW00078-0
Do not use outboard motor if any abnor-
mality is found during pre-operation check
or it could result in severe damage to the
motor or severe personal injury.
Points to Check
WARNING
Remedy
Replenish
Clean
Replace *1
Replenish
Clean
Clean or replace
Remedy or replace *1
Replenish or recharge
Retighten
Remedy or replace *1
Correct or replace *1
Replace *1
Correct *1
Adjust *1
Replace
Tighten
Tighten
Repair if necessary
Replace
69
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

M 70cxM 140a2M 70cM 90a2M 115a2

Table of Contents