TOHATSU M 60C Owner's Manual page 72

70
INSPECTION AND MAINTENANCE
ENOM00082-A
Engine oil replenishing
ENOW00079-A
Do not add engine oil of brand and grade
other than existing one. In case engine
oil of other brand or grade is added,
drain all oil and ask dealer for treatment.
In case other than engine oil such as
gasoline is put in the oil chamber, empty
the chamber and ask dealer for treat-
ment.
When replenishing engine oil, be careful
not to allow entry of foreign matters
such as dust and water into oil chamber.
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
Do not replenish engine oil over upper
limit. If overfilled, remove oil to upper
limit. If engine oil is over the upper limit,
it can leak potentially leading to engine
damage.
If the oil level is low, add recommended oil
to the oil tank.
1. Open the filler lid from the top cowl.
2. Open the oil tank cap
3. Fill the oil tank with the genuine engine
10
oil.
4. After replenishing of the oil tank, be
sure to close the oil tank cap tightly.
CAUTION
1
3
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
ENOM00083-A
Washing outboard motor
ENOW00081-0
WARNING
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors
or in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be
fatal if inhaled for any length of time.
ENOW00920-0
CAUTION
When washing the outboard motor, be
careful not to spray the water inside of the
top cowl, especially electrical components.
2
ENOF01963-0