Starting The Engine - TOHATSU M 60C Owner's Manual

Hide thumbs Also See for M 60C:

Table of Contents

ENGINE OPERATION

3. Squeeze primer bulb until it becomes

stiff to feed fuel to carburetor. Direct

arrow mark upward when priming.

1. Engine side

2. Fuel tank side

Do not squeeze primer bulb with engine

running or when the outboard motor is

tilted up. Otherwise, fuel could overflow.

3. Starting the engine

When the engine is started in the test tank,

to avoid over heating and water pump

damage, be sure the water level is at least

10 cm (4 in.) above the anti ventilation

And be sure to remove the propeller, when

starting the engine in the test tank. (See

Run the engine only at idling.

1. Test tank

3. Over 10 cm (4 in.)

Be sure to stop engine immediately if cool-

ing water check port is not discharging

water, and check if cooling water intake is

blocked. Operating engine could lead to

overheating potentially leading to engine

damage. Consult an authorized dealer if

the cause cannot be found.

Do not keep turning starter motor for over

5 seconds, or the battery may be con-

sumed, potentially making the engine start-

i n g i m p o s s i b l e a n d / o r d a m a g i n g t h e

If cranking over 5 seconds fails to start

engine, return main switch to "ON", and

crank engine again after 10 seconds or

Do not try to crank after engine has

Table of Contents

M 70cx M 140a2 M 70c M 90a2 M 115a2