Daily Inspection - TOHATSU EverRun MX 15E2 Owner's Manual

ENOM01005-0

1. Daily Inspection

Perform the following checks before and
after use.
Item
• Check the amount of fuel in the tank.
Fuel System
• Check for dust or water in the fuel filter.
• Check rubber pipes for fuel leakage.
• Check that the stop switch functions normally and make sure
Electrical
the lock plate is secured.
Equipment
• Check cords for loose connections and damage.
• Check the spark plugs for dirt, wear and carbon build-up.
• Check the choke valve to make sure carburetor is functioning
normally.
Throttle System
• Check if the carburetor and magneto are working normally by
turning the throttle grip, and check for any looseness between
the links.
• Check ropes for wear and chafing.
Recoil Starter
• Check the ratchet for engagement.
• Check that clutch engages correctly when operating the shift
lever and remote control.
Clutch and
• Visually check propeller for bent or damaged blades.
Propeller System
• Check the propeller nut is tightened and the split pin is in correct
position.
Installation of
• Check all the bolts attaching the motor to the boat.
Motor • Check the thrust rod installation.
• After starting the outboard motor, make sure that water is
Cooling Water
being discharged from the cooling water check port.
• Check that there are tools and spare parts for replacing spark
Tools and
plugs, the propeller, etc.
Spares
• Check that you have the spare rope.
• Check if the anode and trim tab are securely installed.
Other Parts
• Check the anode and trim tab for corrosion and deformation.
*1 Have this handled by your dealer.
INSPECTION AND MAINTENANCE
ENOW00078-0
Do not use outboard motor if any abnormal-
ity is found during pre-operation check or it
could result in severe damage to the motor
or severe personal injury.
Points to Check
WARNING
Action
Replenish
Clean or replace
Replace *1
Remedy or replace *1
Correct or replace *1
Clean or replace
Replace *1
Correct *1
Replace *1
Correct or replace *1
Adjust *1
Replace.
Tighten
Tighten
Repair *1
Repair if necessary
Replace
45
10