TOHATSU M 60C Owner's Manual page 39

ENOM01003-0
Auto mixing type
ENOW00604-0
CAUTION
In the unlikely event that gasoline by
mistake is filled into the oil tank, drain
the oil tank completely, and consult an
authorized service shop for advice.
Check the amount of oil in the oil tank
visually before starting the engine. Run-
ning out of oil at sea is a cause for
potential disaster.
The required amount of engine oil is auto-
matically supplied from the oil tank,
through the oil pump, according to the
engine running conditions. Gasoline is fed
over a separate feeding line.
During break-in
Add engine oil into fuel tank. The mixing
ratio with gasoline during break-in is 50:1
(50 parts oil and one part gasoline). Mix
well by hand.
During break-in
ENOM00644-1
Replenishing oil in the engine oil tank.
1. Open the filler lid from the top cowl.
2. Open the oil tank cap.
3. Fill the oil tank with the genuine engine
oil.
4. After replenishment of the oil tank, be
sure to close the oil tank cap tightly.
ENOM00645-0
Oil pump air vent
Visually check whether there is air in the oil
through the vinyl pipe connecting the oil
tank with the oil pump. If present, Purge
the air as follows:
Gasoline : Engine Oil
50 : 1
PRE-OPERATING PREPARATIONS
Loosen the air vent screw on the oil pump
to purge the air, and tighten it when all air,
as seen through the vinyl pipe on the oil
pump side, has been purged.
60/70
1
4
1. Air vent screw
2. To check valve
3. From oil filter
4. Vinyl pipe
90, 115/140
3
4
1. Air vent screw
2. To check valve
3. From oil filter
4. Vinyl pipe
37
4
2
3
ENOF02330-0
1
2
4
ENOF02331-0
6