Writing The Monitor Program Into The Microcontroller; Figure 2-29 Opening The File To Write - Fujitsu F2MC-8FX Series User Manual

AN07-00200-03E
2.2.2

Writing the monitor program into the microcontroller

Preparation
To write programs, it is necessary to set the MODE SW on the starter kit to "PROG" in advance.
Turn OFF the starter kit, switch the mode setting to "PROG", and then turn ON the power supply to
the starter kit again.
To activate the PC writer and select the file to be written as shown in "Figure 2-29 Opening the file
to write", click the "Open" button.
Click

Figure 2-29 Opening the file to write

53