Setting Up The Emulation Software; Download Monitor Program; Making Setup File By Setup Wizard For Emulator; Procedure For Setting Setup File By Setup Wizard - Fujitsu MB95100 Series Application Note

MB2146-09 – Installation Guide
Chapter 4 Setting up the Emulation Software

4 Setting up the Emulation Software

SOFTWARE SETTINGS
For the following steps a Softune 8FX/8L version later than V30L29 is needed.

4.1 Download Monitor Program

Using the Emulator Debugger requires downloading a monitor program to the ICE
(In-Circuit Emulator) according to the chip to be used. The ICE checks the type and
version of the monitor program at start of debugging and loads the monitor program
automatically.
Figure 10: automatic download of monitor program
This sample gives an example of the connection between the ICE (MB2146-09) and
personal computer via USB.
For details, refer to the following manual:
• Softune 8FX/8L First Step Guide

4.2 Making Setup File by Setup Wizard for Emulator

4.2.1 Procedure for Setting Setup File by Setup Wizard

This section explains the procedure for making an additional setup file for the
emulator.
1. Right click on 'Debug' in project-window and choose [Add Setup] -> [New...].
MCU-AN-395002-E-V10 - 14 - © Fujitsu Microelectronics Europe GmbH