Janome JR3000 Series Operation Manual page 73

Point
Point Type
Work Adjustment
Number Set to the point
Work Adjustment
Number Applicable to
X, Y, and R directions
Work Adjustment
Number Applicable to
the Z direction
When drawing an arc from Start of Circle Dispense – Center of Circle Dispense points, or Circle Start
Point – Circle Center Point, only the work adjustment data set to the Start of Circle Dispense or Circle
Start Point applies. Even if you set work adjustment data to a Center of Circle Dispense or Circle
Center Point it is not applicable.
Also note that you cannot set a work adjustment to the Center of Circle Dispense or Circle Center
Points using a PC (JR C-Points II).
MENU [Additional Data Function Settings]
TP
If you move the cursor to a blank line on a point setting screen, the settable point jobs and condition
data for that point are displayed. Select [Workpiece Adjustment] here, and set the workpiece
adjustment number you created.
[Data]  [Additional]  [Work Adjustment]  [Add/Edit]
PC
Dispensing Specifications
P1 P2
Start of
Line
Line
Passing
Dispense
0
(No number 8
is set.)
N/A N/A
N/A 8
[Workpiece Adjustment Settings]
P3 P4
Line End of Line
Passing Dispense
0
(No number 9
is set.)
N/A N/A
N/A 9
72
P5 P6
Start of Center of
Circle Circle
Dispense Dispense
0
(No number 8
is set.)
N/A N/A
N/A N/A
Desktop Robot JR3000