Janome JR3000 Series Operation Manual page 49

 Zigzag Start Point – Rectangle End Point
• Direction: Y Direction
Zigzag Start Point
The robot executes line dispensing back and
forth in a zigzag motion at the specified [Line
Speed] filling in the rectangular area specified
by the Zigzag Start Point and Rectangle End
Point.
If the Z coordinates for the Zigzag Start Point
and the Rectangle End Point differ, the robot
Dispense End Rectangle End Point
changes the height of the Z axis so it dispenses
on a slope while it performs line dispensing.
The robot moves back and forth by splitting up the X direction distance from the Zigzag Start Point to
the Rectangle End Point according to [The Number of Pitches]. The pitch count shown in the diagram
to the top right is 7. The pitch count can be set 2 – 100.
• Direction: X Direction
Number of Pitches
The robot line dispenses back and forth in a
zigzag pattern at the specified [Line Speed], filling
in the rectangular area specified by the Zigzag
Start Point and Rectangle End Point.
If the Z coordinates for the Zigzag Start Point and
the Rectangle End Point differ, the robot changes
the height of the Z axis so it dispenses on a slope
Rectangle End Point
while it performs line dispensing.
The robot moves back and forth by splitting up the Y direction distance from the Zigzag Start Point to
the Rectangle End Point according to the [The Number of Pitches].
The pitch count shown in the diagram on the right is 12. If the number of pitches is an even number,
the Rectangle End Point becomes a Dispense End point.
Dispensing Specifications 48 Desktop Robot JR3000