Purging The Dispensing Agent - Janome JR3000 Series Operation Manual

14. PURGING THE DISPENSING AGENT

You can purge the dispensing agent at your own discretion.
If in Switch Run/External Run Mode, make sure the robot is in run standby.
 Switch Run Mode
Press the purge switch. While the purge switch is pressed the dispenser is ON. Release the purge
switch to turn the dispenser OFF.
 External Run Mode
Turn ON the purge by external signal (#sysIn14). The dispenser is ON when the purge by external
signal (#sysIn1) is ON. Turn OFF the purge by external signal and the dispenser also turns OFF.
 Teaching Mode
Press the purge switch. While the purge switch is pressed, the dispenser is ON. Release
TP
the purge switch to turn the dispenser OFF.
If you are operating the robot from a PC, create and use point job data that turns the
PC
dispenser ON and set the JOG operation dialog to [Point Job].
Point Job Example (the dispenser comes ON for 1 second when executed)
Set #sysOut10
Delay 1000
Reset #sysOut10
Dispensing Specifications 73 Desktop Robot JR3000