Janome JR3000 Series Operation Manual page 66

 Condition Data Dispense Conditions
1. Press the MENU key on the value setting
screen for the start point of the dispensing
operation for which you want to prevent the
dispensing agent dripping at the end of line
dispensing, such as a Start of Line Dispense
point etc. Select [Dispense Condition] and
enter the condition number.
Select [Wait Time at Stop]. The screen for entering the wait time is displayed. Enter the value you
want to set.
2. Call up the value setting screen for the point to where you want to set the dispensing condition and
select the condition number. (Move the cursor (highlight bar) to a blank line on the point setting
screen to display the settable point jobs and condition data.)
3. The condition number entry screen for the dispensing condition is displayed. Set the dispensing
condition number entered in 1. If you press the F3 (LIST) key to display a list of registered
dispensing condition numbers, you can also select the number you want to set from this list.
NOTE
With the following procedure you can
register dispensing conditions and also set
them to points. Select the condition number
from the point setting screen, and press the
F4 (VIEW) key when the dispensing
condition number you want to set is
displayed on the screen (as shown to the
right) to show the information for that
number.
You can select the item you want to edit and
also modify the information here.
The [Wait Time at Stop] is only executed at [Point Dispense], [End of Line Dispense], and/or
dispensing end positions.
Dispensing Specifications
The dispensing operation for which
you want to prevent dripping at the
end of line dispensing
Start of Line Dispense
(Point to Set Dispense
Condition)
Current Number Entered
Enter a number.
Condition Number
DEL COPY
F0 F1
65
Area of dripping
Dispense End
NEW LIST VIEW
F2 F3 F4
Desktop Robot JR3000
1