Janome JR3000 Series Operation Manual page 63

[Dispense Condition] in individual program settings is applied to all line dispensing start points in the
same program. Condition data [Dispense Condition] apply only to points that are set with dispensing
condition numbers.
 Individual Program Settings
[Dispense Condition]
Press the MENU key, select [Individual
Program Settings], and then select [Dispense
Condition]. Select [Wait Time at Start].
The Wait Time at Start entry screen shown on
the right is displayed.
Enter the value you want to register.
 Condition Data [Dispense Condition]
1. Press the MENU key on the value setting screen for the point you want to prevent fragmented
dispensing on at the start of the line dispensing, such as a Start of Line Dispense point, etc., and
select [Dispense Condition] and enter the condition number.
Select [Wait Time at Start]. The screen for entering the wait time (as shown above) is displayed.
Enter the value you want to set.
2. Call up value setting screen for the point for which you want to set the dispensing condition and
select [Condition Number]. (Move the cursor (highlight bar) to a blank line on the point setting
screen to display the settable point jobs and condition data.)
3. The condition number entry screen (as shown below) for the dispensing condition is displayed.
Enter the dispensing condition number entered in 1. Press the F3 (LIST) key to display a list of
registered dispensing condition numbers. You can also select the number you want to set from this
list.
NOTE
With the following procedure you can
register dispensing conditions and also set
them to points. Select [Condition Number]
from the point setting screen, and press the
F4 (VIEW) key on the dispensing
condition selection screen (as shown to the
right) while the dispensing condition number
you want to set is displayed to show the
dispensing condition information for that
number.
You can select the item you want to enter
and also enter the values you want here.
Dispensing Specifications
Enter a number.
Wait Time at Start
Current Number Entered
Enter a number.
Condition Number
DEL COPY
F0 F1
62
0.5 sec.
NEW LIST VIEW
F2 F3 F4
Desktop Robot JR3000
1