Table of Contents
Advertisement
Abbreviated Dialling
15. 2. Setting up a Abbreviated Dialling, Method 2
This method of programming abbreviated dialling is used after an installation is complete. All
calls will be screened because DK (as outlined previously) is automatically set to 08. The
following example assumes the user abbreviated dialling programming code is #2 .
Step
1
2
3
4
5
6
Assuming that by using Method 2, 00 has been assigned the number 0800123456. The number
can be addressed in the following manner:
•
User goes off-hook
•
User dials # 00.
The Dialer will then dial out 0800123456.
Note 1: The # is a flexible prefix. It can be programmed to meet a customer's requirements.
However, the requirements should not conflict with the dialling plan.
Note 2: Do not disconnect the power from the Dialer, until at least 10 seconds have expired
after exiting programming mode. During this period, any programming in the Dialer is being
stored into the Dialer's memory. Disconnecting the power prematurely will result in a loss of
programming, and a checksum error (Refer to page 14).
79
Dial
#2
User abbreviated dialling programming code
NN
Bin location, 00 - 97
MM..MM
Telephone number to be dialled
##
Enters the information into the Dialer's memory
Repeat steps 2 - 4 until all numbers are entered
987
Exits from programming mode
Description
8380-383-115-BA
Issue 1, February 1999
Advertisement
Table of Contents
