Table of Contents
Advertisement
After the Dialer applies modem originate tone, the Dialer can go into either modem or MF4
remote programming mode. If the Dialer and the remote modems connect and the Terminal
Security Code (604) is input, modem programming will be entered. If the carrier presentation
time expires, the Dialer will prompt the programmer for the MF4 Security Code (603) by
sending an MF4 B.
If the trunk is busy at the time of Call Home, the Dialer will wait for the trunk to be freed up.
Once the Dialer has started a Call Home session, either direct dialed or routed, it has fulfilled
its obligation to Call Home, whether the call is answered or not.
13. 5. 014 - Call Home Enable/Disable
You can control whether the Dialer will Call Home.
Register
Default
014 T
13. 6. 600 - Call Home Number
This register stores the pre-defined telephone number that will be used by the Dialer to Call
Home (003 = 0 or 9, in order to be used). The Call Home feature is disabled when this register
is blank.
Register
600
This register contains the Call Home telephone number.
Example: 600 0800123456##
13. 7. 608 - Call Home Time and Day
This register defines the date and time that the Dialer should Call Home. The Call Home
feature is not executed when this register is blank or has an incorrect day or time.
Register
DD = day of the month (00 - 31)
608 DDHHMM
HH = hour of the day (00 - 23)
MM = minutes of the hour (00 - 59)
Example: 608 282301##
8380-383-115-BA
Issue 1, February 1999
T = 0 for Call Home disable
0
T = 1 for Call Home enable
Description
Description
00 = daily calls
01 - 31 = monthly calls
Description
Default
Blank
Call Home
Default
Blank
74
Advertisement
Table of Contents
