Table of Contents
Advertisement
SMarT-1 EuroRoute One-line Dialer Installation
1. 4. Power/line Error Status (Tone)
The Dialer audible error status will be indicated by the following condition:
LED Pattern
† A RAM checksum error occurs when a periodic database integrity check fails, meaning that
the database is corrupted. This condition may be cleared by -initialising the Dialer
1. 5. Standard Installations
The Dialer can be installed and programmed by either an MF4 device or a modem. It is
typically installed as a serial device between a fax machine or a telephone and the Exhange
Line (Figure 1.1).
In order to install the Dialer directly to an Exchange Line:
•
Use the supplied cables to connect the Dialer connector marked "LINE" to the wall outlet.
•
Connect the FAX machine or telephone to the connector marked "FAX".
•
Plug the right angle connector from the power supply to the power input on the Dialer.
Figure 1.1 Dialer Installed between a fax machine or a telephone and the Exchange Line
Telephone wall plug
To
Exchange
Line
Note: The Dialer only uses the "A" and "B wires for a single connection to the Exchange line.
The Dialer can also be installed as a serial device through a PABX (Figure 1.2).
In order to install the Dialer using a PABX Line:
•
Use the supplied cables to connect the Dialer connector marked "LINE" to the wall outlet.
•
Connect the connector marked "FAX" to the FAX machine or telephone.
•
Plug the right angle connector from the power supply to the power input on the Dialer.
Figure 1.2 Dialer Installed between a fax machine and a PABX
PABX
To
Exchange
Line
15
FFF
SMarT-1
Telephone wall plug
Definition
Read Only Memory (RAM) Checksum error
FAX Machine or Telephone
To AC receptacle
SMarT-1
FAX Machine or Telephone
To AC receptacle
†
8380-383-115-BA
Issue 1, February 1999
Advertisement
Table of Contents
