Table of Contents
Advertisement
Basic Hardware Installation
3. 3. Dialer Vertical Mount
The Dialer can be placed on a desk or any other flat surface. The unit may also be mounted
vertically using the supplied clips and associated hardware, as shown in Figure 3.2.
Before mounting the Dialer to a wall, attach the metal clips to the top of the Dialer by pushing
the elevated part of the metal clip into the screw hole. Once the metal clips are attached, the
installer can apply 18mm #6 pan-head screws into pre-made holes in the wall. When attaching
the Dialer to a plaster wall, insert the nylon anchors into the pre-made holes before applying
the 3/4" #6 pan-head screws. The illustration below illustrates the positioning of the clips.
Note: The Dialer can also be vertically mounted using the four Velcro pads that are provided
with the unit.
3. 4. Powering up
The Dialer comes with a power supply. This is the only power supply which will operate the
Dialer reliably. Do not attempt to operate this unit with any other power supply. Plug the right
angle connector into the Dialer, then plug the power supply into a standard 230 VAC wall
outlet.
3. 5. Power Failure
If a power failure occurs, the Dialer will allow calls to be made but will not route the calls.
During a mains power interruption, a one way audio condition may be experienced by either
subscriber on calls that are in progress. If this condition occurs, please hang up and re-try the
call.
3. 6. Spare Parts
•
Euro Power Supply (Europe)
•
Euro Power Supply (UK)
•
Exchange Line Spare Cables
RJ11 plug to RJ11 plug
•
RJ11 plug to BT plug
•
RJ11 plug to BT socket
•
German plug to RJ11 plug
•
Important Product and Safety Information Guide
•
Mounting Clips (Bag of 50)
21
Figure 3.2 . Mounting Position
Rear View
Front View
8380-024
8380-041
8380-036
8380-026
8380-027
8380-042
8380-900-031-BA
8380-043.
Issue 1, February 1999
8380-383-115-BA
Advertisement
Table of Contents
