The Dialer provides easy access (regular dialling patterns) to the local telephone office and to
Long Distance Carriers. The purpose of the Dialer is to set up a call similar to the normal
dialled call. The Dialer can add the Carrier access number and the Personal Identification
Number (PIN) as required for call completion. You can program the Dialer to access a number
based on regular dialling patterns or use abbreviated dialling for rapid access. You can also
program the unit to route or restrict calls based on digits dialled by the user.
In addition, the Dialer allows you to tailor its telephone line parameters for both the
subscriber's telephone equipment and the exchange line. This versatility allows you to satisfy
most situations or user requirements.
1. 6. Programming Devices
The Dialer may be programmed from any of the following devices:
•
MF4 Telephone
•
modem.
The Dialer may also be programmed by using the Mitel software, SMarTMPU.
1. 7. Cost Centre Code Verification
The Dialer can be programmed to request a Cost Centre Code before allowing a call (refer to
Chapter 14 on page 76). The Cost Centre Codes can be assigned to each individual person in
an office, using the telephone lines connected to the Dialer. The codes can vary in type,
according to the route parameters programmed by the maintainer.
8380-383-115-BA
Issue 1, February 1999
SMarT-1 EuroRoute One-line Dialer Installation
16