Chapter 7; System Wide Data; General; 002 - Called Party Programming Enable/Disable - Mitel SmarT-1 8380-003-FBCXTX Installation And Programming Manual

7. System Wide Data

7. 1. General

You can change System Wide Data if the default data does not meet your requirements.

7. 2. 002 - Called Party Programming Enable/Disable

You can specify whether a called party may enter into programming mode after a call is
originated from a line attached to the Dialer.
Register Default
002 T
Note: If Centrex is enabled and the subscriber dials a local call (does not dial the Centrex
digit(s), they will not be able to enter Called Party Programming, but will remain in a cut
through state.

7. 3. 011 - Carrier Presentation Time for Modem

You can specify the time the internal V.21 300 baud modem will present carrier and try to
establish communication before the Dialer defaults back to MF4 mode programming.
Register Default
011 T

7. 4. 015 - Rotary Dialling Break Percentage

You can specify the rotary dialling break percentage for either 60 or 66.6 percent.
Register Default
015 T
8380-383-115-BA
Issue 1, February 1999

CHAPTER 7

T = 0 Disable
1
T = 1 Enable
T = 0 For modem disable
T = 1 For 1 second
T = 2 For 2 seconds
T = 3 For 3 seconds
T = 4 For 4 seconds
T = 5 For 5 seconds
T = 6 For 6 seconds
T = 7 For 7 seconds
T = 8 For 8 seconds
T = 9 For 9 seconds
T = For 10 seconds
T = 0 For 60% break
0
T = 1 For 66.6% break
System Wide Data
Description
Description
Description
38