Installation
4.5 AC Side Insulator Installation
CAUTION! RISK OF ELECTRICAL HAZARD!
!
- To avoid electrical hazard, please turn off all DC & AC power before
installation and removal.
After wiring at AC side, if the gap between different two-phase terminals is within
10 mm, please install the U-type insulator to prevent terminals from touching.
1. Turn off all DC and AC Power, and make sure there is no
remaining electricity on both DC and AC sides.
2. Tear the double-sided tape on back side of U-type insulator.
3. Stick the insulator on AC busbar.
double-sided tape
Figure 4-11 : AC Side U-type Insulator Installation
38