1. Remove the field operation lock pin from the lock position and install it below the frame in the storage
position. See Graphic below..
2. Lift the harrow using the Main Lift Circuit until the
hydraulic cylinders are fully retracted.
3. Rotate the Wing wheels into transport position. This
will also release the wing tension link locks. If the
tension link locks do not come undone you may
have to back up slightly to release the lock if it is
wedged. Note: The hydraulic cylinders for the wing
wheels and wing lock are on one circuit. The wheel
cylinders will not actuate until the lock cylinders
retract completely as the lock cylinders take less
pressure.
DHX-360/DHX-600
03/21
© 2021 Alamo Group Inc.
OPERATION
Operation Section 4-10