Table of Contents
Advertisement
Only tow the Implement behind a properly sized and equipped Tractor whose weight is at
least 75% of that of the implement. DO NOT tow the Implement behind a truck or other type
of vehicle. Never tow the Implement and another Implement connected in tandem. Never
tow the Implement at speeds over 20 MPH.
Secure the Implement for transport before traveling on public roads.
Implements, secure the center axle using cylinder stops or transport pin and properly attach
a safety chain between the Implement and Tractor. Secure wings in upright position on
folding Implements using wing transport locks.
Your driving vision may be reduced or impaired by the tractor, cab, or implement. Before
driving on public roadways identify any limited vision areas, and make adjustments to your
operating position, mirrors, and the implement transport position so that you can clearly
see the area where you will be traveling, and any traffic that may approach you. Failure to
maintain adequate vision of the public roadway and traffic can result in serious injury or
even death.
Lock the disc gangs in the raised position before transporting the Implement.
Implement and/or road damage could result from unintentional dropping of the discs gangs.
Be sure to pin the tractor drawbar rigid in the center position and properly attach the
Implement safety tow chain.
Concluding Safety Instructions and Practices
In addition to the design and configuration of this Implement, including Safety Signs and Safety Equipment,
hazard control and accident prevention are dependent upon the awareness, concern, prudence, and proper
training of personnel involved in the operation, transport, maintenance, and storage of the machine. Refer
also to Safety Messages and operation instruction in each of the appropriate sections of the Tractor and
Equipment Manuals. Pay close attention to the Safety Signs affixed to the Tractor and Equipment.
Note: Schulte supplies safety decals on this product to promote safe operation. Damage to the decals may
occur while in shipping, use or reconditioning.Schulte cares about the safety of its customers, operators, and
bystanders, and will replace the safety decals on this product in the field, free of charge (Some shipping and
handling charges may apply). Contact your Schulte dealer to order replacement decals.
DHX-360/DHX-600
03/21
© 2021 Alamo Group Inc.
SAFETY
(STI-10)
(STL-9)
Safety Section 1-11
(STI-7)
For pull-type
Serious
(SG-18)
Advertisement
Table of Contents
