Table of Contents
Advertisement
TRACTOR PREPARATION
Have a tractor with sufficient horsepower and traction. Normally, 8 hp/ft of DISC HARROW is required. This
horsepower requirement can be lower or higher depending upon field and soil conditions/type/moisture and
desired disc depth and operating speed. Have your tractor adequately equipped to operate at speeds of 9 - 13
MPH as this speed will provide the best results.
All personnel should wear hard hats, safety shoes, safety glasses, and proper hearing
protection at all times during the assembly process for protection from injury.
Always read carefully and comply fully with the manufacturer's
instructions when handling oil, solvents, cleansers, and any other
chemical agent.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
The components of this implement are very heavy. Securely lift the components using
appropriate and adequate lifting devices. Block all components up securely before working
or reaching under components.
Use extreme caution when getting onto the Implement to perform assembly procedures or
maintenance. Only stand on solid flat surfaces to ensure good footing. Use a ladder or
raised stand to access high spots which cannot be reached from ground level. Slipping and
falling can cause serious injury or death.
Use genuine SCHULTE parts and fasteners. These parts are made and tested to SCHULTE
specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The
use of "will fit" parts may reduce the implements performance, void warranties, and present
a safety hazard.
Use caution and wear protective gloves when handling sharp objects such as blades,
knives, and other cutting edges. Be alert to worn component surfaces which have sharp
edges. Sharp surfaces can inflict severe laceration injuries if proper hand protection is not
worn.
DHX-360/DHX-600
03/21
© 2019 Alamo Group Inc.
ASSEMBLY
(SG-22)
(SG-14)
(SG-37)
Assembly Section 3-2
Advertisement
Table of Contents
