Mounting Angle Adjustment Range - Panasonic SF4-AH Series Instruction Manual

Table of Contents

3-2-4

Mounting Angle Adjustment Range

The height adjustment of the emitter and the receiver was described in '3-2-1 Mounting

Procedure'. This section explains the method of adjusting the horizontal mounting angle with

respect to the mounting surface.

1. Confirm that the two the hexagon-socket-head bolts [M3 (length 5mm)] for adjusting the

mounting angle at the top and the bottom of the sensor are loosened. In case the

intermediate supporting bracket is used, loosen the hexagon-socket-head bolt [M4 (length

10mm)] for position adjustment of the U-shaped rear (side) supporting bracket and

L-shaped intermediate supporting bracket, too.

2. Adjust the mounting angle so that the emitter and the receiver face each other, and then

tighten the hexagon-socket-head bolts. (Tightening torque: 0.6N·m or less)

Further, firmly tighten the bolts that temporarily hold the U-shaped rear mounting

supporting bracket and the L-shaped intermediate supporting bracket. (Tightening torque:

1.8N·m or less)

By this procedure, the mounting angle can be adjusted up to ±15°. For accurate positioning, refer to

'3-4-1 Beam-axis Alignment' for details. The same procedure is to be performed for both side, as

well as, rear mounting.

- 54 -

Table of Contents