Cable Specification - Panasonic SF4-AH Series Instruction Manual

3-3-3

Cable Specification

Connect the mating cable (with connector on one end, or connector on both ends) to the
connector of the sensor main body (emitter and receiver).
Wire the other side of the mating cable according to the customer's application referring to
the connector pin arrangement given below.
 When extending the cable, use the exclusive cable up to the total length of
 When the synchronization cable is extended with a cable other than exclusive
Cable / connector color
Emitter Gray / Gray
Gray (with black stripe) /
Receiver
Black
<Reference>
 In the table on the previous page, Orange / Black indicate that the basic wire color is orange,
respectively, and they have a black stripe on them.
 The length L of the connection cable is different depending on the
model No.
 The connectors can be distinguished from their color as follows.
Connector for emitter: gray, connector for receiver: black
- 58 -
20.5m (for emitter / receiver). Extending the cable longer than 20.5m may cause
malfunction, which can result in serious injury or death.
2
cable, use a ø0.2mm or more, shielded twist pare cable, and connect the shield to
the frame ground (F.G.) of the machine that the sensor is mounted to without fail.
Pin No.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
© Panasonic Industrial Devices SUNX Co., Ltd. 2013 MJE-SF4A No.0038-55V
Lead wire color
-
Brown
Pink
Gray
Orange
Orange / Black
Blue
-
White Control output 2 (OSSD 2)
Brown
Black Control output 1 (OSSD 1)
-
Orange
Orange / Black
Blue
-
Model No.
SF4A-CC3
SF4A-CC7
SF4A-CC10
Description
Not connected
24V DC
Emission halt input
Auxiliary output
Synchronization +
Synchronization -
0V
Shielded
24V DC
Not connected
Synchronization +
Synchronization －
0V
Shielded
Cable length
L (m)
3
7
10