3-4 Adjustment
3-4-1
Beam-axis Alignment
1. Turn ON the power supply unit of this device.
2. Check that the fault indicator (yellow) of the emitter and receiver are off respectively.
If the fault indicator (yellow) lights up or blinks, refer to 'Chapter 5 Troubleshooting',
and report the symptoms to the maintenance in charge.
<Reference>
Refer to '3-2-1 Mounting Procedure' for the operations beyond this.
For laser alignment, it is useful to use the beam alignment tool for light curtain (SF-LAT-2N)
(optional).
3. Loosen the two hexagon-socket-head bolts [M3 (length 5mm)] for adjusting the mounting
angle at the top and the bottom of the emitter.
<Reference>
If the intermediate supporting bracket has been mounted on the sensor main body, loosen the
hexagon-socket-head bolt for position adjustment [M4 (length 10mm)] before alignment.
© Panasonic Industrial Devices SUNX Co., Ltd. 2013 MJE-SF4A No.0038-55V
- 61 -