Mounting; Mounting Of The Mounting Bracket - Panasonic SF4B-F23 V2 Instruction Manual

Light curtain / type4

Table of Contents

2-4 Mounting

● Mount the emitter and the receiver at the same level and parallel to each other. The effective aperture

angle of this device is ±2.5° or less for a sensing distance of 3m or more.

● Unless otherwise specified, the following mounting procedure is common for both emitter and receiver.

For the preparation of the mounting, prepare the mounting holes on the mounting surface by referring to

"6-3 Dimensions."

1. Set the device with its mounting hole on the side just overlapping with the mounting hole

of the M8 rear mounting bracket, and fix the M8 rear mounting bracket with the accessory

hexagon-socket head bolt [M5 (length: 18mm)]. The tightening torque should be 1.2N·m or

less.

M8 Rear mounting bracket

(MS-SFB-7-T) (Optional)

Main body

(Rear side)

● For selecting the appropriate mounting bracket matched to the installation

environment, the mounting bracket is not incorporated in this device. Please

purchase the optional mounting bracket to fit on the mounting environment.

● Do not apply the load such as forced bending to the cable of this device. Apply-

ing improper load could cause the wire breakage.

● The minimum bending radius of the cable is R6mm. Mount the device consider-

ing the cable bending radius.

In case mounting the mounting bracket after mounting the bottom cap cable and

the series connection cable, be sure drawing the cable to other side of the hexa-

gon-socket head bolt to prevent the cable from press by the bolt.

Good

Hexagon-socket head bolt

[M5 (length: 18mm)]

(Enclosed with MS-SFB-7-T)

Not good

Good Not good Good Not good

Table of Contents