Panasonic SF4-AH Series Instruction Manual page 11

Table of Contents

It emits light to the receiver facing it.

Further, status of the emitter and the receiver is indicated in its display section.

It receives light from the emitter facing it, and turns the control output (OSSD 1, OSSD 2) to

ON when light is received from the emitter for all beam channels, and to OFF when light is

blocked even for one beam channel. Further, the receiver status is indicated in its display

section.

Note: The blanking function is set using the handy-controller (SF-HC) (optional). Please purchase the

handy-controller separately.

The light emitting elements of the emitter and the light receiving elements of the receiver are

placed at an interval of 20mm.

This bracket is to be used for mounting the emitter / receiver from the rear. It enables the

mounting angle to be adjusted. The rear sensor mounting brackets included in the packing

are designed specifically for rear mounting. If side mounting is required, please place an

order for the optional side sensor mounting brackets (MS-SF2N-3).

<U-shaped rear mounting intermediate supporting bracket, L-shaped intermediate

supporting bracket>

These brackets are to be used to attach the sensor with its total length of the sensor be 36

beams channels or more to the place where is attached by intense vibration. Please note that

the enclosed U-shaped rear intermediate supporting brackets are designed specifically for rear

mounting. If side mounting is required, please place an order for the optional side intermediate

supporting brackets (MS-SF2N-4 or MS-SF4A-H4 for '-H' type). The L-shaped intermediate

supporting bracket is used for rear mounting and side mounting in common.

- 11 -

Table of Contents

Troubleshooting