Panasonic SF4-AH Series Instruction Manual page 44

Table of Contents

When using the intermediate supporting bracket, it is not possible to mount the

center mounting bracket (MS-SF2N-5) to the aluminum frame.

1. Choose the sensor mounting bracket to suit the application, and temporarily tighten the

two hexagon-socket head bolts [M3 (length 5mm)] for adjusting the mounting angle. After

beam-axis alignment, tighten the bolts completely. (Tightening torque: 0.6N·m or less)

Match the projection of the sensor mounting bracket with the concavity in the sensor main body, and

hook the sensor mounting bracket on the projections on the sensor, for easy installation.

2. Temporarily mount the sensor mounting bracket (top and bottom) on the mounting surface

with the two hexagon-socket-head bolts [M5 (please arrange separately)].

3. Match the position of the emitter and the receiver (upper surface) to the same height by

adjusting within the range of the oblong hole, and then securely tighten the

hexagon-socket-head bolts.

One method of matching the height is to put a metal plate (which does not bend in the middle) on the

upper surface of the emitter and the receiver and then adjust by placing a level gauge at the middle

of the metal sheet.

4. Fix the intermediate supporting bracket with the two hexagon-socket-head bolts [M5

(please arrange separately)]. (36 beam channels, or more)

- 44 -

Table of Contents

Troubleshooting