Mounting; Mounting Of The Mounting Bracket - Panasonic SE4D Series Instruction Manual

2-4 Mounting

2-4-1 Mounting of the Mounting Bracket

<Reference>
● Mount the emitter and the receiver at the same level and parallel to each other. The effective aperture
angle of this device is ±2.5° or less for a sensing distance of 3m or more.
● Unless otherwise specified, the following mounting procedure is common for both emitter and receiver.
For the preparation of the mounting, prepare the mounting holes on the mounting surface by referring to
"6-3 Dimensions."
● For selecting the appropriate mounting bracket matched to the installation
environment, the mounting bracket is not incorporated in this device. Please
purchase the optional mounting bracket to fit on the mounting environment.
● Do not apply the load such as forced bending to the cable of this device. Apply-
ing improper load could cause the wire breakage.
● The minimum bending radius of the cable is R6mm. Mount the device consider-
ing the cable bending radius.
In case mounting the mounting bracket after mounting the bottom cap cable and
the series connection cable, be sure drawing the cable to other side of the hexa-
gon-socket head bolt to prevent the cable from press by the bolt.
Good Not good
20