Table of Contents
Advertisement
4. Installation
4.1. Car door drive
4.1.1. Installation of car door drive
Installation sequence for mounting the drive:
Details on position numbers in brackets in the figure
1. Remove nut on insulating rubber (2) and mounting bolt (11) on mounting elbow (12).
2. Place V-groove belt (3) on serrated lock washer of the transmission shaft (1) and insulating rubber (2). Align
belts for installation with the motor drive shaft.
3. Turn back tightening screw (9) on the motor console.
4. Place motor with motor console (7) on mounting elbow (12) and insulating rubber (2).
5. Place V-groove belt on drive and transmission shaft and tension by moving the motor.
6. Loosely screw motor console to mounting elbow and insulating rubber.
7. Tension V-groove belt by tightening the tightening screw. 1) Observe notices and remarks regarding belt
tension in Fig. 13!
8. Tighten mounting bolts and secure the adjustment of the tightening screw with the counter nut on the tight-
ening screw (Fig. 12).
9. Open and remove cover on controller housing with a Philips screwdriver.
10. Passing them through the cable bushing, connect the connections of the controller on the door drive motor
with the control system.
11. Connect motor and controllers according to instructions and the terminal connecting plan. See Chap. 4.2 on
page 25.
Note !
After completing commissioning, the controller housing has to be closed with the cover. This is important for both versions
KFM LD • Instruction manual
Item
Designation
1
Transmission shaft
2
Insulating rubber
3
V-groove belt
4
Motor
5
Inspection switch
6
Control device
7
Motor console
Fig. 12
Item
Designation
8
Insulating rubber
9
Tightening screw
10
Header
11
Motor attachment screw
12
Mounting elbow
13
Drive shaft
14
Toothed belt for drive
Tab. 17
23
Advertisement
Table of Contents
