Engine Shut-Off Cord (Lanyard) And Clip; Main Switch - Yamaha F200 Owner's Manual

When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU25996

Engine shut-off cord (lanyard) and clip

The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord during
normal operation. Loss of engine power
means the loss of most steering control.
Also, without engine power, the boat
could slow rapidly. This could cause peo-
ple and objects in the boat to be thrown
forward.
[EWM00123]
ZMU05819
1. Engine shut-off cord (lanyard)
2. Clip
3. Engine shut-off switch
1. Engine shut-off cord (lanyard)
2. Clip
3. Engine shut-off switch
EMU41552

Main switch

The main switch controls the ignition system;
its operation is described below.
 "
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
 "
" (on)
With the main switch in the "
the electrical circuits are on, and the key can-
not be removed. The engine can be started
by pressing the Start/Stop button.
 "
Components
" (off)
" (start)
3
2
1
ZMU07143
3
2
1
ZMU07144
" (off) posi-
" (on) position,
32