Throttle Friction Adjuster; Engine Shut-Off Cord (Lanyard) And Clip - Yamaha LF200 Owner's Manual

matically to its set position. The remote con-
trol will then engage forward and reverse
normally.
EMU25976

Throttle friction adjuster

A friction device provides adjustable resis-
tance to movement of the throttle grip or the
remote control lever, and can be set accord-
ing to operator preference.
To increase resistance, turn the adjuster
clockwise. To decrease resistance, turn the
adjuster counterclockwise. WARNING! Do
not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to move the remote control lever
or throttle grip, which could result in an
accident.
[EWM00032]
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU25995
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not route
the cord where it could become entangled,
preventing it from functioning. Avoid acci-
dentally pulling the cord during normal
operation. Loss of engine power means
the loss of most steering control. Also,
without engine power, the boat could slow
rapidly. This could cause people and ob-
jects in the boat to be thrown forward.
[EWM00122]
ZMU04563
1. Cord
2. Clip
ZMU04646
3. Engine shut-off switch
Components
2
1
ZMU04565
3
25