Digital Electronic Control Requirements; Battery Requirements; Specifications Of Battery - Yamaha F200 Owner's Manual

Specifications and requirements
mode, and only be started in the unlock
mode. Consult your Yamaha dealer for instal-
lation of the receiver.
EMU34954
Digital electronic control re-
quirements
The digital electronic control is equipped with
a start-in-gear protection device(s). This de-
vice prevents the engine from starting unless
it is in neutral.
EWM01581
WARNING
 If the engine starts in gear, the boat can
move suddenly and unexpectedly, pos-
sibly causing a collision or throwing
passengers overboard.
 If the engine ever starts in gear, the
start-in-gear protection device is not
working correctly and you should dis-
continue using the outboard. Contact
your Yamaha dealer.
This digital electronic control unit is only
available for the outboard motor which you
have purchased.
Prior to use of the digital electronic control
unit, set it in order to operate your outboard
motor only. Otherwise, it will not be possible
to operate the outboard motor.
Perform setting of the outboard motor and
the digital electronic control unit in the follow-
ing cases.
17
 If a used outboard motor is installed
 If the digital electronic control unit is re-
placed
 If the ECM (Electronic control module) of
the used outboard motor is replaced
 If the ECM (Electronic control module) of
the digital electronic control unit is re-
placed
Consult your Yamaha dealer for setting.
EMU25695
EMU44721

Specifications of Battery

ZMU07305
Use a fully charged battery that meets the fol-
lowing specifications. The engine cannot be
started if battery voltage is too low.
For North America
Battery rating (CCA/SAE):
680–1150 A
Battery rating (MCA/ABYC):
770–1370 A
Battery rating (RC/SAE):
160 minutes
For Oceania
Battery rating (CCA/EN):
640–1080 A
Battery rating (20HR/IEC):
80 Ah
ECM01063
NOTICE
 Do not use a battery that does not meet
the specified capacity. If a battery that
does not meet specifications is used,
the electric system could perform poor-
ly or be overloaded, causing electric
system damage.
 Do not use a battery which exceeds the
maximum CCA rating. If the batteries
are used in parallel circuit, use new bat-

Battery requirements