matically to its set position. The remote
control will then engage forward and re-
verse normally.
EMU40606
Throttle friction adjuster
The throttle friction adjuster can be used to
adjust the resistance to movement of the re-
mote control lever, and can be set according
to operator preference. Adjust the throttle
friction according to the following procedure.
(1) Remove the cap.
1
1. Cap
1
1. Cap
(2) To increase resistance, turn the adjuster
clockwise. To decrease resistance, turn
the
adjuster
WARNING! Do not overtighten the fric-
tion adjuster. If there is too much re-
sistance, it could be difficult to move
the remote control lever, which could
result in an accident.
counterclockwise.
[EWM02581]
1. Throttle friction adjuster
1
1. Throttle friction adjuster
(3) Install the cap.
EMU25996
Engine shut-off cord (lanyard) and clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord during
normal operation. Loss of engine power
Components
1
29