Inspecting Wiring And Connectors; Inspecting Propeller - Yamaha F200 Owner's Manual

Maintenance
leaks. NOTICE: If the low oil pressure-
alert indicator comes on or if there are
oil leaks, stop the engine and find the
cause. Continued operation with a
problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01623]
14. Apply LOCTITE 572 to the threads of the
bolts and screw, and then install the
apron.
TIP:
LOCTITE 572 is used as a sealant.
15. Install the top cowling.
16. Dispose of used oil according to local
regulations.
TIP:
 For more information on the disposal of
used oil, consult your Yamaha dealer.
 Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
EMU29116

Inspecting wiring and connectors

 Inspect that each connector is engaged se-
curely.
 Inspect that each ground lead is properly
secured.
87
EMU41671

Inspecting propeller

EWM02681
WARNING
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller. Before inspecting, remov-
ing, or installing the propeller, move the
control lever to the neutral position, turn
the main switch to the "
remove the key, and remove the clip from
the engine shut-off switch. Turn off the
battery cut-off switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Place a block of wood between the anti-
cavitation plate and the propeller to prevent
the propeller from turning.
ZMU07779
ZMU07996
" (off) position,