Cutting The Ecdry Floor Heating Element To Size - Danfoss ECdry 55 Installation Manual

Installation Guide
1�1

Cutting the ECdry floor heating element to size

Each end of the ECdry heating element con-
sists of 25 cm without electrical parts inside.
The ECdry heating element may only be cut
at the far ends where there are no electrical
parts inside as marked on the product below.
Markings and symbols have been printed on
the ECdry heating mats:
Cutting area
Do not cut area. Electrical parts
inside. If cut, element will be de-
stroyed.
To cut the element to size:
Carefully measure the piece you wish to cut
off and simply cut with a sharp knife.
16 | Danfoss © | 2020.07
Danfoss ECdry Touch Kit
K
E M
A
K
E M
A
AN324050550815en-000201