Danfoss ECdry 55 Installation Manual page 23

Installation Guide
• Unroll the extension cords entirely to
prevent the cords from overheating.
• Do not pull the cord or the floor heating
element to undo a plug-in connection.
Always use the connection tool.
• If the extension or supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or similar
persons in order to avoid a hazard.
• Connect the floor heating to 230 Volt and
50 Hz only.
Danfoss © | 2020.07
Danfoss ECdry Touch Kit
• Do not allow needles, sharp objects,
liquids and/or other electricity-conducting
objects/fluids to make contact with the
floor heating system.
• The printed side of the heating element
must be visible when placing the element
showing the symbol:
THIS SIDE UP
• Save the manual together with the
warranty papers for further use.
K
E M
A
AN324050550815en-000201 | 23