Filling Up The Remaining Space - Danfoss ECdry 55 Installation Manual

Installation Guide Danfoss ECdry Touch Kit
1�1

Filling up the remaining space

At this point all connections between the
elements should be aligned and connected
and as much of the floor as possible should
be covered with ECdry elements. The space
without ECdry heating mats should be cov-
ered with the ECdry Filler Material to ensure
an even and homogenous floor surface.
A knife, a lineal (to cut along) and a wooden
plate (behind the ECdry element) can be
used when cutting the ECdry Filler Material
to avoid cutting into the electrical parts and
ensuring a straight cut.
To be certain that the distribution of the
floor heating mats in your room is correct,
we suggest you make everything fit before
you secure the elements permanently. It is
most important to make sure that all plug-in
connections are perfectly aligned to allow
the flow of electricity from one element to
the next. Put the floor heating mats plus any
filler materials down as shown in the lay-out.
Once you have correctly positioned all floor
heating mats and you have cut the filler
material to size, you can proceed with the
permanent installation as explained in the
following steps.
Fit the output cord
Cut a piece of material from the filler mate-
rial to embed the output cord between the
ECdry Controller and the ECdry heating mat.
Danfoss © | 2020.07 AN324050550815en-000201 | 17