Safety Precautions - Danfoss ECdry 55 Installation Manual

Installation Guide
7

Safety Precautions

• Use the floor heating element for the
purposes described in the installation
manual only.
• ECdry must always be installed with the
ECdry Touch Kit.
• The ECdry floor heating system is to be
supplied through a residual current device
having a rated residual operating current
not exceeding 30 mA.
• Means for disconnection must be
incorporated in the fixed wiring in
accordance with the wiring rules.
• All the used ECdry elements must have
the same area output.
• The ECdry elements are not to be installed
on irregular surfaces.
• Bending diameter of the floor heating
mats is 100 mm.
• ECdry heating element must be separated
from other heat sources.
• Be careful not to separate or move the
heating mats during installation.
• The ECdry heating element must not be
installed at ambient temperatures below 5 °C.
• The ECdry floor heating system is only for
indoor use.
• When storing the ECdry floor heating
element keep it rolled as from factory or
laying flat, never standing unrolled up
against a wall/ in vertical position
22 | Danfoss © | 2020.07
Danfoss ECdry Touch Kit
• Do not install or use the floor heating
system after one or more components
have been damaged.
• Do not allow home repairs under any
circumstances. Repairs must be carried
out by qualified electricians. Faulty repairs
may cause personal injury or damage to
property.
• Do not use the floor heating in combination
with parts that are not recommended,
installed or supplied by Danfoss.
• Use original parts of the ECdry floor
heating system only. The warranty for the
entire system and for the separate parts
becomes null and void if parts from other
manufactures have been used.
• Make sure that no hot spots develop
when using the floor heating system.
Avoid hot spots by ensuring that the heat
from the floor heating is homogeneously
released to the area you wish to heat.
Do not install the floor heating element
under permanent or built-in cupboards
(min. 6 cm air).
• Do not use the ECdry floor heating system
if the system is wet.
• Warning label should be filled out
and placed next to the distribution
switchboard.
• The ECdry floor heating system is only to be
used with the ECdry extension cords (The
ECdry X). Do never cut the extension cords.
• Do not buckle the supply cord and the
extension cords; do not have them run
across hot and/or sharp objects.
AN324050550815en-000201