Wiring - Optex Smart Line Series Installation Instructions Manual

Battery operated photoelectric detector
Table of Contents

Advertisement

3-6 WIRING

This product is provided with wiring based on the assumption that
N.C. wireless transmitters are used.
Connect the cables from the back box (Yellow/Yellow-white,
Green/Green-white, and Black/Black-white) to the respective
terminals on the wireless transmitters.
Receiver
Main unit
Red
Black
Orange
Brown
Yellow
White
Green
Blue
Purple
Gray
Main unit
POWER
DQ
+
NO
NC COM
Back box
+
POWER
NOTE>>
• To perform the wiring as shown above, two
wireless transmitters are required and one
of them must have two outputs.
Back box
Red
Power input (+)
Black
Power input (-)
Orange
DQ output
Brown
DQ output
Yellow
Alarm output
White
Alarm output
Green
Low Battery output
Blue
Low Battery output
Purple
Tamper output
Gray
Tamper output
LB
TAMPER
ALARM
NC
NO
COM
NC
COM
NC
COM
Input
Input
Input
Input
(N.C.)
(N.C.)
(N.C.)
(N.C.)
Wireless transmitter
EN-7
Transmitter
Main unit
Red
Black
Green
Blue
Main unit
Purple
Gray
POWER
+
Back box
+
POWER
• When using BCU-4 (option), be sure to
read the BCU-4 manual. Do not insert
batteries into the wireless transmitter.
Doing so may result in fire or explosion.
NOTE>>
• To monitor all signal outputs independently, include a
wireless transmitters with four inputs or use two wireless
transmitters with two inputs each.
• If there is only an N.O. output on a wireless transmitter,
the low battery output and tamper output cannot be used.
Switch D.Q. output and alarm output from N.C. to N.O.
• When you want to use the D.Q. output, share the terminal
with the alarm, low battery, or tamper output. For
information about wiring, see the wiring diagram in "Setting
the D.Q. output" in "4-3" on page 10.
• The power supply can be shared between the back box and
wireless transmitter by using battery common use unit
Battery common use unit BCU-4 (option).
Back box
Red
Power input (+)
Black
Power input (-)
Green
Low Battery output
Blue
Low Battery output
Purple
Tamper output
Gray
Tamper output
LB
TAMPER
COM
NC
COM
NC
Input
Input
(N.C.)
(N.C.)
Wireless transmitter
Warning

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sl-350 qfrSl-350 qnr

Table of Contents