Optex Smart Line Series Installation Instructions Manual page 4

5
Run the cables so that they are not pinched between the
chassis and back box.
6
Pass the cables through the wiring hole of the chassis and
mount the chassis to the back box.
Caution
• Tighten the screws
completely by torque
of 1.0 - 1.5 N·m.
Not doing so may
fasten
cause malfunction of
wall tamper.
Pull
fasten
fasten
Caution
• Avoid cables from being caught between chassis.
• When the waterproof packing is detached, be sure to
attach it on the back of the chassis before mounting.
Not doing so may compromise IP rate of this
product.
7
Fix the main unit on the chassis.
1 Insert the lower part, and
then push the upper part
onto the chassis.
2
Turn the optical unit 90 degrees
and tighten the screws (both sides).
Banding band
Wiring notch
Force into
a groove
EN-4
8
Connect the cables and complete setting and alignment.
(refer to page 8, 9)
Note>>
• For more information on wiring, see "WIRING" on page 7.
9
Close the cover.
1 Hook on the upper part of
the chassis.
2 Push the lower part of
the cover until it clicks
into position.
3 Fasten the cover lock screw.
Note>>
• Put the cables in order
not to be caught
between the main unit
and cover.
• Push the middle part of
the cover and hide this
orange label
completely when in
operation.
Caution
• Do not contact with the optical unit when mounting
the cover. Otherwise malfunction may occur due to
the shift of the optical axis, resulting in the need of
readjustment.
Orange label