Table of Contents
Advertisement
NOTE:
OLP-87/OLP-87P
The selected set is displayed.
Measuring in Pass/Fail mode
You must set the threshold levels before you can make
measurements in Pass/Fail mode.
1.
Select a threshold set.
[A]
2.
Press the
key.
3.
Tap the
[Pass/Fail]
– or –
Tap several times on the right side of the touchscreen, until the
Pass/Fail results are displayed.
Deleting a threshold set
The Edit Threshold Sets menu is displayed.
I
1.
Select the threshold set that you would like to delete.
[A]
2.
Press the
key.
3.
Tap the [Delete
Set]
The Delete menu is displayed:
4.
To delete the threshold set, tap the
5.
To exit the menu without making any changes press the
key.
Displaying relative power level
The actual measured power level relative to a reference value is
displayed in relative power display mode. The reference value
can be set by defining the actual power level as the reference
value. This setting can then be edited manually.
D
ISPLAYING RELATIVE POWER LEVEL
button.
button.
[OK]
6 PON
O
METER
PERATION
button.
[F]
47
Hide quick links:
Advertisement
Table of Contents
