Table of Contents
Advertisement
Mechanical installation
78
───
Do not exceed the permissible axial forces
If the motor shaft cannot be inserted easily, the screw on the
clamping hub must be loosened a little more.
With certain motor shaft diameters, a slotted spacer sleeve must
be installed in addition. If there is a groove on the motor shaft, it
must be aligned with the slot in the spacer sleeve.
► Insert the motor shaft [1] into the clamping hub [2]
► Make sure that no gap is created between the motor and the
adapter plate
This example shows a motor size with four fixing points in the
flange.
► Coat screws [1], [2], [3] and [4] with threadlocker
► Insert bolts [1], [2], [3] and [4] and tighten evenly
► Tighten bolt [5]. Refer to the chapter "Clamping hub", [Page 75].
► Insert the screw plug back into the adapter plate
AG2400
Version: 2.1
Advertisement
Table of Contents
