Motor On Gear Unit - Beckhoff AG2400 Operating Instructions Manual

Motor on gear unit

8.2
Clamping hub
8.2.1
Version: 2.1
If a motor is included in the scope of delivery:
Motors included in the scope of delivery are pre-mounted.
For optimum performance, we recommend installation on Beckhoff
AM8xxx synchronous servomotors.
Requirements for the attachment of a motor to the gear unit:
• The design of the motors is B5
• The concentricity tolerance or axial run-out tolerance is available
according to DIN 50347
• The motor has a cylindrical shaft end with tolerance class h6 up
to k6
• Motor attachment if possible in a vertical position
The following table provides a description of the clamping hub:
Infographic Position
H
I
J
K
L
• Clamping screw according to ISO 4762
AG2400
Mechanical installation
Name
Clamping bolt
Clamping ring
Spacer sleeve
Grooved motor shaft
Smooth motor shaft
─── 75