Modules And Cards - Mitel 3300 General Information Manual

The following accessories are supported:
• Mitel IP Programmable Key Modules (12 and 48)
• Mitel IP Paging Unit
• Power Dongle (Cisco compliant)
• PowerDsine 24PT In-line Power Unit
• PowerDsine 12 PT In-line Power Unit
• Wireless LAN (WLAN) Stand
• Gigabit Ethernet (GigE) Stand
• Line Interface Module
The following legacy telephones, consoles, and accessories can be used with the 3300 ICP if
a peripheral unit with a DNI card is connected to the system:
• SUPERSET 4015 Digital Phone
• SUPERSET 4025 Digital Phone
• SUPERSET Interface Module 2
• SUPERCONSOLE 1000
• SUPERSET 410
• SUPERSET 420
• SUPERSET 430
• Mitel 12 PKM
• Mitel 48 PKM
• SUPERSET Interface Module 1
• DNIC Music On Hold/Pager Unit (DMP)
Analog telephones can also be connected to a 3300 ICP using a ASU II AMB (Cx, CXi and
MXe Controller), AOB (Cx or CXi) or peripheral unit with an ONS Line Card.

Modules and Cards

Modules are field replaceable units (FRUs) that expand the functionality and capacity of the
controller. They are installed in three to eight slots, depending on the controller. Communication
interface modules—the Dual FIM, T1/E1 module, T1/E1 Combo Card, and Quad BRI Framer—
are installed in the slots on the front panel with external access. The CX/CXi and MXe use the
same analog main board (AMB). The analog boards provide embedded analog capability on
the controller.
This section covers the following:
• Quad Digital Signal Processor
• Echo Cancellation Module
®
System
21