Mounting Of The Pellet Burner - Effecta Smart 40 Installation, Maintenance, Service, Assembly

Mounting the pellet burner
▀
Below assembly guidance is only for the Effecta Supra burner. We cannot
recommend use of any other burner in the boiler. An underfed burner can
not be used.
The mounting arm cannot be mounted on a existing boiler it can only be
mounted from factory. Contact Effecta for alternative solutions.
1. Remove the cover plate on the top door. Use a sharp knife around the cover plate to avoid
paint damages when removing the cover plate.
2. Mount the burner flange with the heat proof sealing. Use the bolts that held the cover plate.
3. To cover the flange, the insulated heat shield should be mounted.
4. Mount the bracket for the mounting arm on prefferable side of the boiler..
5. Mount the rigid arm to the bracket with two bolts.
6. Mount the second arm (u-profile) that will be connected to the burner..
7. Mount the adapter plate for the burner in the predrilled hole in the U-profile.
8. Use the predrilled holes to mount the Supra burner on to the adaptor plate.
9. Mount the control unit where preffered. If equipped with AERO make sure that it will be within
the range of the pressure hose.
▀ Components for swiveling mounting arm
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
32
1 Adapter plate, pellet burner
2 Mounting bolts for bruner M8
3 Mounting bolts heat shield M8
4 Insulation for heat shield
5 Cover for heat shield
6 Bracket for mounting arm
7 Swiveling arm from boiler
8 Swiveling arm for pellet burner