Table of Contents
Advertisement
Door adjustment
▀
There are a number of ways to adjust the door. In the pictures below you can see the hinge
on the door. After some use, some adjustments maybe is needed so the gaskets do not draw
extra air to the boiler.
1. Adjustments in depth
If the gasket does not seal tightly against the hinge
side, loosen the two bolts that hold the hinge in place
of the door frame. Release the bolts around two turns
and adjust the door inwards to tighten the lid and inverted
to release the pressure on the gasket.
2. Vertical adjustment
To centre the gasket on the door frame in height,
loosen the two bolts on the outside of door. Release
the bolts around two turns and adjust the door.
3. Adjustment sideways
To centre the gasket on the door frame to the side,
loosen the two above the number of millimetres that
the adjustment needs. Tighten the short side door with
two bolts.
Adjustment of the door locking
If the gasket does not seal tightly on the handle side,
loosen the two bolts (1.) that hold the bracket in place.
Loosen around two turns and slide the latch inwards to
tighten the lid and outward to release the pressure. If
the door handle is not in the vertical position with the
flip closed, you can adjust the bolt (2.) up or down to
change position.
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - info@effecta.se
29
Advertisement
Table of Contents
