Sub-Fc71(0X47): Set 8 Locked Periods; Set 8 Locked Periods - ICP DAS USA ACS-20B-MRTU User Manual

5.2.28 Sub-FC71(0x47): Set 8 Locked Periods

This command sets 8 locked periods in a day to module. One locked period composed of
Start Time and End Time. The End Time should be late after the Start Time.
Byte Description
order
00 Address
01 FC
02 Sub-FC
03 P1 Start Hour
04 P1 Start Minute
05 P1 Start Second
06 P1 End Hour
07 P1 End Minute
08 P1 End Second
09~44 P2 to P7 ...
45 P8 Start Hour
46 P8 Start Minute
47 P8 Start Second
48 P8 End Hour
49 P8 End Minute
50 P8 End Second
Byte order Description
00 Address
01 FC
02 Sub-FC
03 Result
ACS-20B(W)-MRTU User Manual
Copyright © 2021 ICP DAS Co., Ltd. All Rights Reserved
Table 5-59: FC100-Sub-FC71 Request
Size Value
1 Byte 1 ~ 247 (Net ID)
1 Byte 0x64
1 Byte 0x47
1 Byte 0 ~ 23, period 1 start Hour
1 Byte 0 ~ 59, period 1 start Minute
1 Byte 0 ~ 59, period 1 start second
1 Byte 0 ~ 23, period 1 end Hour
1 Byte 0 ~ 59, period 1 end Minute
1 Byte 0 ~ 59, period 1 end second
36 Bytes period 2 ~ 7 start time and end time
1 Byte 0x00
1 Byte 0x00 ~ 0xFF, enabled state of 8 periods
1 Byte 0x00
1 Byte 0x00 ~ 0xFF, enabled state of 8 periods
1 Byte 0x00
1 Byte 0x00 ~ 0xFF, enabled state of 8 periods
Table 5-60: FC100-Sub-FC71 Response
Size Value
1 Byte 1 ~ 247 (Net ID)
1 Byte 0x64
1 Byte 0x47
1 Byte 0x00 => OK
Others => Error, bit0~bit7 correspond to
period1~period8. Bit value=1 means invalid
settings.
Version 1.1
E-mail: service@icpdas.com
54
Page：