Table of Contents
Advertisement
2/ Extracting and Inserting a Node Module
2.1. Extracting a Node Module
ESD-Sensitive Device!
Take all necessary ESD protection measures.
Steps in
1.
Press the power button of the node to be extracted. (The power button should be configured in the operating
system so it performs a clean shutdown when pressed.)
2.
The ID LED of the node becomes steady blue: the node is ready to be extracted.
3.
To extract the node module from the slot, pull on the handle while pressing the safety lock (Figure 8) towards
the left.
Figure 8: Processor node module safety lock location
blue
apply only to hot swap procedures.
www.kontron.com
MSP8040 Series User Guide Rev. 1.2
// 21
Advertisement
Table of Contents
