Infrared Board - HP ENVY x360 13 Maintenance And Service Manual

The infrared board cable is available in the Cable Kit, spare part number L94507-001.
Before removing the infrared board cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
1. Battery (see
2. Solid-state drive (see
3. Fan (see
4. System board (see
Remove the infrared board cable:
1. Release the ZIF connector (1) to which the infrared board cable is connected, and then disconnect the
infrared board cable from the infrared board.
2. Remove the infrared board cable (2).
Reverse this procedure to install the infrared board cable.

Infrared board

To remove the infrared board, use this procedure and illustration.
58 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 34)
Solid-state drive on page
Fan on page 38)
System board on page
33), and then remove the following components:
37)
53)
33).
ENWW